Plumbing & HVAC Services in Egg Harbor City, NJ

HVAC & Plumbing Service Summary Completed Work 1. Upstairs Heating Tune-Up * Performed a heating tune-up on the upstairs HVAC system. * Inspected the system for proper operation and performance. * Homeowner declined the heating tune-up on the downstairs unit at this time. 2. Whole-Home Plumbing Inspection * Performed a visual inspection of accessible plumbing fixtures, piping, and connections throughout the home. * Plumbing fixtures and systems appeared to be operating properly at the time of inspection, with the exceptions noted below. 3. Laundry Room Bathroom Sink * Observed evidence of a previous water leak underneath the bathroom sink located near the laundry room. * Unable to determine the exact source of the previous leak during the inspection. * Advised homeowner to monitor the area for any additional signs of moisture or leaking. * Recommended installing a water alarm underneath the sink to provide early detection of future leaks. 4. Kitchen Sink Plumbing * Observed ev

Acid Neutralizer & Water Softener Combo System Service Completed Work 1. System Inspection * Inspected the existing acid neutralizer and water softener combination system. * Visually inspected the equipment, piping, and connections for leaks or operational concerns. 2. Acid Neutralizer Service * Added calcite media to the acid neutralizer as needed. * Inspected the system for proper operation after servicing. 3. Water Softener Service * Customer added salt to the water softener using salt already available at the home. * Inspected the water softener for proper operation. 4. Control Head & Programming * Inspected the control/timer head and reviewed the existing programming. * Adjusted regeneration times, timer settings, and applicable control settings as needed. * Cycled the system and verified that the control head, valves, and regeneration functions were operating properly. 5. Final System Check * Reviewed the overall operation of the water treatment system. * System was te

HVAC Service Summary Completed Work 1. System Inspection * Upon arrival, the customer stated that the boiler room make-up air damper located on the wall was not opening and closing properly. * Inspected the make-up air damper motor and associated electrical operation. 2. Electrical Testing * Verified that the damper motor was receiving the required high voltage. * Confirmed that the motor itself had the capability to open and close. * Determined that the motor was not receiving the required low-voltage control signal to command damper operation. 3. Findings * The make-up air damper motor appeared capable of operating, but the required low-voltage control signal was not being supplied. * Further diagnosis of the boiler control system and make-up air controls was required to determine the source of the missing signal. Recommendations * Advised the maintenance staff to contact a qualified commercial HVAC or commercial boiler service company for further diag

Water Heater Replacement Service Summary Completed Work 1. Existing Water Heater Removal * Removed and properly disposed of the existing water heater. 2. New Water Heater Installation * Furnished and installed a new 50-gallon Bradford White natural gas power-vent water heater. * Installed a new expansion tank. * Installed a new drain pan. * Installed a new water detection alarm. 3. Plumbing & Venting Connections * Reconnected the existing hot and cold water lines to the new water heater. * Reconnected the existing exhaust/vent piping as required. * Completed all necessary connections in accordance with applicable local codes. 4. System Testing * Restored the water and gas supply. * Tested the newly installed water heater for proper operation. * Inspected accessible connections for leaks and confirmed proper operation at the time of completion. Warranty * 10-Year Tank Warranty * 10-Year Parts Warranty * 2-Year Labor Warranty Additional Wo

Summary of Services Provided *Arrived on site to perform annual maintenance on acid neutralizer system. *Inspected water treatment equipment and plumbing fixtures during service. *Performed annual acid neutralizer service and confirmed system is operating properly. *Identified lavatory faucet in bathroom as damaged and restricting water flow. *Identified well system pressure gauge as nonfunctional. *Discussed findings and recommendations with customer. *Replaced lavatory faucet and secured all connections. *Tested faucet and confirmed proper operation with no leaks. *Customer had a prior commitment and was unable to remain on site for pressure gauge replacement. *Pressure gauge replacement will be scheduled for a future visit. *Membership inspection will also be completed during the follow-up appointment. *Everything is functioning properly at this time. Findings *Lavatory faucet was damaged and restricting water flow. *Pressure gauge on well system is nonfunctional and requires repla

Summary of Services Provided *Arrived on site and found leaking emergency shut-off valve servicing toilet. *Inspected valve and found it deteriorating and beginning to fail. *Customer advised home is supplied by well water and does not currently have a water treatment system. *Discussed water quality concerns and recommended installation of water treatment equipment in addition to valve replacement. *Turned water off to perform repairs. *Cut open wall with customer authorization to gain proper access to piping. *Installed new piping down into crawlspace and re-piped toilet water supply. *Installed new emergency shut-off valve and new toilet supply line. *Installed new whole-home acid neutralizer system to bring water pH into proper balance and reduce corrosiveness. *Turned water back on and tested all work performed. *Confirmed no leaks and verified proper operation of plumbing and water treatment systems. *Everything is functioning properly at this time. Findings *Emergency shut-off

Summary of Services Provided *Arrived on site and customer advised existing dishwasher had failed and required replacement. *Removed existing dishwasher from kitchen. *Disposed of old dishwasher for customer. *Installed new customer-supplied dishwasher. *Secured all water, drain, and electrical connections. *Tested dishwasher and confirmed proper operation. *Checked all connections and verified no leaks at this time. *Everything is functioning properly at this time. Findings *Existing dishwasher had failed and required replacement. Recommendations *Recommend periodic inspection of connections and proper use to ensure longevity of new unit. Warranty *One-year warranty on labor for dishwasher installation only. *No warranty on dishwasher itself, as it was supplied by the customer. Thank You For Choosing ASAP Plumbing, Heating & Cooling! Please Dave’s service today!

Upon arrival, customer requested estimate on new HVAC system. Provided customer with multiple options. All options include a free membership for the first year, which includes two free tuneups. All options also include a lemon warranty. Which, in the event of a major mechanical component failure within the first year full system will be replaced. All options also include a complementary air scrubber. Any questions please don’t hesitate to call the office and ask for Sam

HVAC Service Summary Completed Work 1. AC Tune-Up • Performed an air conditioning tune-up. • Verified the system was operating according to manufacturer specifications. • Measured a 16° temperature split with an indoor temperature of 65°, confirming system operation. 2. System Inspection • Inspected the evaporator coil and condensate drain setup. • Identified that no safety switch was installed on the evaporator coil. • Found the existing P-trap was a glued trap, making it inaccessible for proper cleaning and maintenance. 3. Condenser Inspection • Inspected the condenser coil. • Noted signs of corrosion beginning to form. • Confirmed the unit should continue operating for a few more years. Recommendations • Easy Trap & Safety Switch Installation • Recommended installing an easy trap along with a safety switch. • This will allow proper access for cleaning and maintenance of the drain line. • The safety switch will help prevent water overflow and potential system damage. • Estimate

Upon arrival, I was asked to install a customer-supplied vanity. Installation would require modifying the cabinet to properly accommodate the existing drain line; however, this would involve significant alterations to the cabinet, including drilling or cutting out approximately 2–3 slats to allow space for the drain and water lines. I advised the customer of these conditions. Additionally, I informed the customer that a widespread faucet will need to be supplied to complete the installation. We will supply the P-trap and AAV to allow for proper drainage let us know how Dan did